Skip to main content

High Flux Tube Heat Exchanger

High Flux Tube Heat Exchanger

High flux tube is bare tube evenly coated with a thin layer porous metal with multiple micro pores and interconnected tunnels. Surface porous coat not only increases heat transfer area, but also forms innumerable nucleation site to largely increase nucleation rate. Interconnected pores can also agitate local liquid during bubbling process, further increasing heat transfer coefficient outside tube. With synergy of many enhancements, heat transfer efficiency is greatly improved.

Features

Compared to bare tube, heat transfer area can be reduced by 27.5%.

Equipment operation capacity can be increased by 20%.

Total heat transfer coefficient is increased by 89%.

Boiling can be achieved by lower temperature difference. The requirement of heat source temperature is decreased with outstanding energy conservation effect.

Application

Widely used for reboiler, evaporator, condenser and so on when there is phase transition.

Tube Specs

Diameter: ф12～ф60 mm

Coat Thickness: 0.13～0.5 mm

Material: CS, SS, Cu and Cu Alloy, Ti and Ti Alloy, Ni alloy etc.

Comments

Post a Comment

Popular posts from this blog

What is tube sheet layout?

What is tube sheet layout? A tube sheet is a component used in shell and tube heat exchangers and other types of heat transfer equipment. It is a flat plate with holes drilled in it, through which tubes are inserted and secured. The tube sheet serves as a barrier between the two fluids, allowing heat to be transferred from one to the other. The layout of the tube sheet depends on the design of the heat exchanger, which includes the number of tubes, the size of the tubes, and the spacing between the tubes. The layout is typically determined using computer-aided design (CAD) software, which can optimize the placement of the tubes to achieve the desired heat transfer performance. In general, the tubes are arranged in a triangular or square pattern on the tube sheet. The triangular pattern is often preferred because it provides better support for the tubes and reduces the risk of vibration and damage. The spacing between the tubes is also important, as it affects the flow rate and pressure...
Post a Comment
Read more

What is aluminum finned tubes?

What is aluminum finned tubes? Aluminum finned tubes are a type of finned tube air heat exchanger that uses aluminum fins attached to a tube made of a different material, such as copper or steel. The aluminum fins are typically extruded or formed to increase the surface area of the tube, which in turn increases the efficiency of heat transfer. Aluminum finned tubes are commonly used in HVAC systems, as well as in industrial and power plant applications. They are preferred over other types of finned tubes in some applications because they are lightweight, corrosion-resistant, and have good thermal conductivity. Additionally, aluminum is relatively inexpensive compared to other metals commonly used in heat exchangers, such as copper and stainless steel. The specific properties of aluminum finned tubes can vary depending on the alloy used to make the fins. For example, aluminum fins made from alloys such as 6061 and 3003 have good corrosion resistance and thermal conductivity, while those...
Post a Comment
Read more

What is the difference between pipe bends and elbows?

Bends and elbows are fittings used to change the direction of a pipe. These two kinds of pipe fittings have a wide range of applications in construction, but in actual use, the performance of pipe bends and elbows is different, and elbows are used much more than pipe bends. What is the difference between pipe bends and elbows? An elbow is a pipe part with a bend, which is a commonly used pipe part. Bends are usually manufactured to specific needs. Compared with the elbow, the elbow is much longer and is a curved pipe, while the elbow is only a part that changes the direction of the pipe. Although both are components that change the direction of the pipeline, there are many differences between these two components. 1. Different manufacturing processes for  pipe bends and elbows In the manufacturing process cold and hot bent pipes can be made of pipe bends, which directly bent by the pipe bending machine, and the  bent pipe  can be manufactured at one time without secondary...
Post a Comment
Read more